Exterior Cleaning

Clean the surface area with a damp towel. Use mild cleaning detergent or non-abrasive detergent.

Interior Cleaning

To keep the auger and bowl clean the toilet is equipped with a special rinse feature. By pressing a red button on the side of the toilet, water will get rinsed in the bowl. A water reservoir that holds 0.25 gallon of water is located under the bowl. Clean the toilet bowl periodically with a standard commercial toilet cleaner.

WARNING!  

• Never use flammable cleaning detergent when cleaning ECOJOHN™ Sr.

REMOVAL OF ASH

The removal of ash of ECOJOHN™ Sr should be done when refilling the Propane cylinder (5.0 gallon cylinder).

• In order to avoid burns - wait at least 5 hours after the last burn cycle or usage before attempting to remove the ash.

To clean the burn chamber, follow these steps:

1. Disconnect the Propane and the Power.
2. Disconnect Chimney Cover Clamp.
3. Remove Insulation.
4. Disconnect Connector Clamp.
5. Free Sr from Chimney System (move it sideways).
6. Remove Top Toilet Lid.
7. Remove Cover Plate on top of Burn Chamber.
8. Remove Insulation.
9. Unscrew Cleaning Lid located on the top of the Burn Chamber or unscrew three screws on top of the Burn Chamber, disconnect Power Connection, and lift the Burner up.
10. Use a Wet/Dry Vacuum, such as ShopVac, to clean up the remaining ash inside the burner.
11. Close Cleaning Lid or reattach the Burner, connect Power Connection, and tighten the three screws.
12. Add Insulation.
13. Add Cover Plate on top of Insulation and Burn Chamber.
14. Reattach Top Toilet Lid.
15. Push Sr back underneath the Chimney System.
16. Connect the Connector Clamp.
17. Add Insulation.
18. Connect Chimney Cover Clamp.
19. Connect the Propane and Power.
20. DONE

Figure 1. A picture showing how sterile ash can be cleaned out from the burn chamber

Figure 1.